Mechanical services restricted to duct fixing work

This class allows you to carry out restricted components of the class of mechanical services:

• The installation, alteration or repair of any duct, regulator, register or any other item
  associated with the air handling system in the heating, cooling or ventilation of a building.
• It includes roof and wall penetrations and flashings associated with duct fixing.

Typical work under this restricted class

Areas of experience (AoEs)

Persons registered or licenced in this class typically carry out the following work:

• fabricate and install solid and/or flexible ductwork
• roof and wall penetrations and flashings associated with duct fixing.

Compliance requirements

Registered and licenced practitioners in this class must interpret and apply the compliance requirements for this class outlined in:

• Building Act 1993
• Plumbing Regulations 2018
• WorkSafe Victoria requirements for plumbing work and building construction sites
• National Construction Code (NCC), Vol 3
• Relevant Australian Standards (see permitted assessment reference materials).

Additional compliance requirements for licenced practitioners

Licenced practitioners hold a greater level of responsibility and must interpret and apply the following additional compliance requirements:

• Issue compliance certificates
• Knowledge of Performance Solutions
• WorkSafe Victoria requirements for supervising staff (including supervision of apprentices)
• Hold relevant insurance.

Registration and licensing requirements

All persons who apply for registration or licence in this restricted class – unless applying via mutual recognition (MR) – must successfully complete the relevant BPC exam(s). You are permitted to bring relevant reference materials to your exams.

Registration

To be eligible to apply for this restricted class, you must meet the following conditions:

• Have at least 2 years of experience in the required AoEs.
• Provide a Technical referee report from a suitably qualified licenced plumber in this restricted class or Mechanical services work.
• Be able to interpret and apply the compliance requirements for this class.
• Meet one of the following education requirements:
  • Have successfully completed the prescribed units for Mechanical services relating to this work
  • Have successfully completed the prescribed safety units for this class and can demonstrate the same knowledge and skill as a person who has completed all the relevant prescribed units.

Once you submit your application, you must successfully complete the registration exams for this class.

Licensing

To become licensed in this class, you must meet the following conditions:

• hold (or be eligible) to hold registration in this class
• have an additional 12 months of practical experience
• hold the prescribed units for licence in this class.

Useful links

• Apply for a plumbing registration or licence
• Prescribed units
• Plumbing exams
• Permitted assessment materials